Side hinged exit doors must be used to connect rooms to exit routes.
Require buffer floor area for passageways exit door.
Exit components include walls floor doors or other means that provide the protected path necessary for the occupants to proceed with reasonable safety to the exterior of the building.
A exits shall be so located and arranged that they are readily accessible at all times.
It shall comply with the following requirements.
Where there is only one exit access leading to an exit or exit discharge the width of the exit and exit discharge must be at least equal to the width of the exit access.
Basically if a door doesn t have a lock with a push pull or a latch the door is not legally required to need panic hardware.
1910 36 g 3 the width of an exit route must be sufficient to accommodate the maximum permitted occupant load of each floor served by the exit route.
An external exit passageway can be used as a required exit in lieu of an internal exit passageway.
Exit routes must support the maximum permitted occupant load for each floor served and the capacity of an exit route.
Travel to the exit discharge is how the building codes define the exit.
An exit may comprise vertical or horizontal means of travel such as doorways stairways ramps corridors and passageways.
R rationale clause 2 3 2c an exit passageway provides the same level of protection from the effects of fire and smoke as an exit staircase.
Every storey of a building shall be provided with exit facilities for its occupant load.
Sometimes panic hardware is called fire exit hardware or they may be referred to as egress doors.
Panic hardware cannot be used on a fire door because of the danger of trapping people inside during a fire.
These doors must swing out in the direction of exit travel if the room is to be occupied by more than 50 people or if the room is a high hazard area.
Examples of exits as defined by the building codes include exterior exit doors separated exit stairs and exit passageways.
This is the part of the definition with which manufacturers and suppliers are the most concerned.
Sps 375 24 2 2 every standard exit door shall swing outward or toward the natural means of egress except as below and as in s.
The determination of exit requirements for a building shall be based upon the type of use or occupancy of the building the occupant load the floor area the travel distance to an exit and the capacity of exits as provided in table 2 2a and herein.