Slide the clevis about 2 inches along.
Repair unattached trip lever in wall mount sink.
Lift the lever up as far as it will go then insert the end into the nearest hole on the clevis sliding the clevis up or down the rod as necessary to do this.
You should now see screws holding the bracket to the wall.
While it uses the same faucet handles as the previous version the spout is changed to a metal version and the trip lever for the drain rotates behind the spout.
The floor sink should be placed in front of the plumbing.
Step 2 place a small bucket on the floor beneath the water valves to catch any water left in the lines then disconnect each of the lines with an adjustable wrench.
The plunger piece provides the plug in the sink s drain assembly keeping the water that runs into the sink from draining out.
Exposed pipes are not aesthetically striking.
Turn off the water supply to the fixture at the two small water valves mounted on the wall beneath the sink.
Now you ll lift up and slide the sink off the bracket holding it to the wall then set aside tighten loose sink bracket.
The plumbing should have an accurate position.
You must detach the plunger from the sink s drain assembly in order to clear out large clogs or to replace the rubber pad on the underside of the plunger.
Note the hexagonal escutcheons and metal cross handles.
Lift up the sink.